IC7000 manual.PDF
(
4818 KB
)
Pobierz
<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.01//EN" "http://www.w3.org/TR/html4/strict.dtd">
INSTRUCTION MANUAL
HF/VHF/UHF
ALL MODE TRANSCEIVER
i7000
IMPORTANT
EXPLICIT DEFINITIONS
READ THIS INSTRUCTION MANUAL
CAREFULLY
before attempting to operate the
transceiver.
WORD
DEFINITION
Personal injury, fire hazard or electric
shock may occur.
R
WARNING
SAVE THIS INSTRUCTION MANUAL.
This
manual contains important safety and operating in-
structions for the IC-7000.
CAUTION
Equipment damage may occur.
If disregarded, inconvenience only. No
risk or personal injury, fire or electric
shock.
NOTE
FOREWORD
SUPPLIED ACCESSORIES
We understand that you have a choice of many differ-
ent radios in the market place. We want to take a cou-
ple of moments of your time to thank you for making
the IC-7000 your radio of choice, and hope you agree
with Icom’s philosophy of “technology first.” Many
hours of research and development went into the de-
sign of your IC-7000.
The transceiver comes with the following acces-
sories.
Qty.
q
Hand microphone (HM-151) ........................ 1
w
DC power cable* (OPC-1457) ..................... 1
or (OPC-1457R) ............... 1
e
Spare fuse (ATC 5 A) ................................... 1
r
Spare fuse (ATC 30 A) ................................. 2
t
ACC cable......................................................1
y
3.5 (d) mm plug..............................................1
u
6.5 (d) mm Electronic keyer plug ...................1
i
Microphone hanger ........................................1
o
Ferrite bead**.................................................1
* Depending on versions.
**Not supplied with non-European versions.
q
D
FEATURES
❍
IF DSP features
❍
All mode capability covering 160–2 m and
70 cm (depending on version)
❍
Compact with detachable front panel
❍
±0.5 ppm of high frequency stability
❍
Baudot RTTY demodulator
❍
Simple band scope function
t
❍
Selectable SSB transmission passband
width (For both higher and lower pass fre-
quency)
yu
i
❍
Standard voice synthesizer/voice recorder
w
Spurious signals may be received near the following fre-
quencies. These are created in the internal circuit and does
not indicate a transceiver malfunction:
52.76497 MHz,
443.03535 MHz
For European versions
w
o
(see p. 19 for installation details)
Icom, Icom Inc. and the logo are registered trademarks
of Icom Incorporated (Japan) in the United States, the United
Kingdom, Germany, France, Spain, Russia and/or other
countries.
OPEN
THIS P
THIS P
AGE
AGE
i-1
ILLUSTRATIONS
Front panel
!6
@4
@3
@2
@1
@0
!9
!8
!7
q
w
e
!5
t
yu
i
o
!0
!1
!2
!4
!3
r
HM-151
⁄3
⁄2
z
S
PCH
/LOCK
TUNER
/CALL
XFC
⁄1
x
⁄0
MW
V/M
c
v
.
F-2
F-1
,
Mic element
1.8
3.5
7
m
MODE
1
2
3
10
14
18
FIL
n
4
5
6
b
21
24
28
GENE
7
8
9
50
.
144
430
F-INP
ENT
0
CE
The front panel and HM-151’s panel
descriptions are descrived on pages
1 to 4, and on page 9, respectively
(see the
Chapter 1 ‘
PANEL
DE-
SCRIPTION’ for more details).
i-2
■
Front panel
■
Microphone (HM-151)
q
AF GAIN CONTROL [AF]
(inner control; p. 33)
z
SPCH/LOCK KEY [SPCH/LOCK]
(p. 34, 37)
w
RF GAIN CONTROL/SQUELCH CONTROL
[RF/SQL]
(outer control; p. 35)
x
PTT SWITCH
[PTT]
(p. 37)
c
UP/DOWN SWITCHES [
Y
]/[
Z
]
e
POWER KEY [PWR]
(p. 25)
v
TRANSMIT INDICATOR
(p. 37)
r
FRONT PANEL LATCH
(p. 16)
b
KEYPAD
(pgs. 28, 29)
t
PASSBAND TUNING/M-ch/RIT CONTROLS
[PBT/M-ch/RIT]
(pgs. 73, 77, 86, 100, 104)
n
FILTER SELECTION [F
IL]
(p. 75)
m
MODE KEY [MODE]
(p. 34)
y
TWIN PBT (M-ch/RIT) INDICATOR
(pgs. 73, 77, 86, 100)
,
POWER INDICATOR
u
MENU/GROUP KEYS [MENU/GRP]
(p. 151)
.
PROGRAMMABLE FUNCTION KEYS [F-1]/[F-2]
i
TUNER/CALL KEY [TUNER/CALL]
(pgs. 100, 114)
⁄0
MEMORY WRITE [MW]
(pgs. 101, 102)
⁄1
VFO/MEMORY SELECTION [V/M]
(pgs. 27, 100, 107)
o
MULTI-FUNCTION KEYS [F1]/[F2]/[F3]/[F4]
(pgs. 5–8, 151)
⁄2
TRAN
SMIT FREQUENCY CHECK [XFC]
(pgs. 65, 89)
!0
MANUAL NOTCH KEY [MNF/ADJ]
(p. 81)
!1
AUTO NOTCH/VOICE RECORDER KEY
[ANF/
•
REC]
(pgs. 80, 93)
⁄3
TUNER/CALL KEY [TUNER/CALL]
(pgs. 100, 114)
!2
SPCH/LOCK KEY [SPCH/LOCK]
(pgs. 34, 37)
!3
MICROPHONE CONNECTOR
(p. 10)
!4
UP/DOWN (BAND) KEYS [
Y
(
BAND
)]/[
Z
(
BAND
)]
!5
MAIN DIAL TENSION LATCH
!6
HEADPHONE JACK [PHONES]
(p. 18)
!7
MAIN DIAL [DIAL]
!8
RECEIVE/TRANSMIT INDICATORS [RX]/[TX]
!9
TUNING STEP KEY [TS] (
pgs. 30–32)
@0
NOISE BLANKER KEY [NB/ADJ]
(p. 78)
@1
NOISE REDUCTION KEY [NR/LEV]
(p. 79)
@2
FUNCTION DISPLAY
(p. 13)
@3
PRE AMP/ATTENUATOR KEY [P.AMP/ATT]
(p. 72)
@4
MODE KEY [MODE]
(p. 34)
i-3
PRECAUTIONS
R
WARNING RF EXPOSURE!
This device emits
Radio Frequency (RF) energy. Extreme caution should be
observed when operating this device. If you have any
questions regarding RF exposure and safety standards
please refer to the Federal Communications Commission
Office of Engineering and Technology’s report on Evalu-
ating Compliance with FCC Guidelines for Human Radio
Frequency Electromagnetic Fields (OET Bulletin 65).
R
WARNING HIGH VOLTAGE! NEVER
touch an
antenna or internal antenna connector during transmis-
sion. This may result in an electrical shock or burn.
R
WARNING! NEVER
operate the transceiver while
driving a vehicle. Safe driving requires your full atten-
tion—anything less may result in an accident.
R
NEVER
apply AC power to the [DC13.8V] socket on
the transceiver rear panel. This could cause a fire or dam-
age the transceiver.
R
NEVER
apply more than 16 V DC, such as a 24 V
battery, to the [DC13.8V] socket on the transceiver rear
panel. This could cause a fire or damage the transceiver.
R
NEVER
let metal, wire or other objects touch any in-
ternal part or connectors on the rear panel of the trans-
ceiver. This may result in an electric shock or this could
cause a fire or damege the transceiver.
R
NEVER
connect or use the supplied HM-151 (micro-
phone) with other transceiver. This could cause damage
to the transceiver. The HM-151 is designed for use with
the IC-7000
ONLY
.
NEVER
expose the transceiver to rain, snow or any liq-
uids.
AVOID
using or placing the transceiver in areas with tem-
peratures below –10°C (+14°F) or above +60°C (+140°F).
Be aware that temperatures on a vehicle’s dashboard can
exceed +80°C (+176°F), resulting in permanent damage
to the transceiver if left there for extended periods.
AVOID
placing the transceiver in excessively dusty envi-
ronments or in direct sunlight.
AVOID
placing the transceiver against walls or putting
anything on top of the transceiver. This will obstruct heat
dissipation.
Place unit in a secure place to avoid inadvertent use by
children.
During mobile operation,
NEVER
place the transceiver
where air bag deployment may be obstructed.
During mobile operation,
DO NOT
place the transceiver
where hot or cold air blows directly onto it.
During mobile operation,
DO NOT
operate the transceiver
without running the vehicle’s engine. When the trans-
ceiver’s power is ON and your vehicle’s engine is OFF,
the vehicle’s battery will soon become exhausted.
Make sure the transceiver power is OFF before starting
the vehicle engine. This will avoid possible damage to the
transceiver by ignition voltage spikes.
During maritime mobile operation, keep the transceiver
and microphone as far away as possible from the mag-
netic navigation compass to prevent erroneous indica-
tions.
BE CAREFUL! The rear panel will become hot when op-
erating the transceiver continuously for long periods.
BE CAREFUL! If a linear amplifier is connected, set the
transceiver’s RF output power to less than the linear am-
plifier’s maximum input level, otherwise, the linear ampli-
fier will be damaged.
Use Icom microphones only (supplied or optional). Other
manufacturer’s microphones have different pin assign-
ments, and connection to the IC-7000 may damage the
transceiver.
For U.S.A. only
Caution:
Changes or modifications to this transceiver,
not expressly approved by Icom Inc., could void your
authority to operate this transceiver under FCC regu-
lations.
ii
Plik z chomika:
sp3imm
Inne pliki z tego folderu:
IC-7300_pl.pdf
(18232 KB)
IC-7300_ENG.pdf
(23720 KB)
FT-847 POL.pdf
(81239 KB)
ID-5100E_PL.pdf
(25350 KB)
IC-E2820_PL.pdf
(8641 KB)
Inne foldery tego chomika:
BRAMKA Linksys PAP2T-EU
Dokumenty
Galeria
GM 350
LEDy wyswietlacze
Zgłoś jeśli
naruszono regulamin